Customer Portal REQUEST A QUOTE
ENEnglish

UPCOM
Field Support

Field preparation

ElektroFOK Quick Start

Use these checks before operation and before requesting ElektroFOK support.

Model: ElektroFOK
Cable range: 1–8 mm

Safety note

Stop operation before inspection, cleaning, or adjustment. Follow the official manual and site safety rules.

Before you start

  • Confirm the machine label shows ElektroFOK.
  • Record the serial number.
  • Confirm cable OD is within the ElektroFOK 1–8 mm range.
  • Confirm duct OD / connection size is within the ElektroFOK 4–18 mm range.
  • Confirm duct cleanliness and continuity.
  • Confirm visible cable path.

Setup check

  • Confirm electric motor, control panel, remote control, air connection, and duct connection condition according to the official manual.
  • Use the ElektroFOK Setup Wizard to review cable, duct, and UPCOM Code references before support handoff.
  • Confirm installed setup details before operation.
  • Stop if torque/speed behavior appears unstable.

Start procedure

  • Position the machine on a stable working area.
  • Prepare cable, duct, air connection, control interface, and cable path according to the official manual.
  • Start only after the setup is checked and measurements are recorded.
  • Continue only while cable movement is smooth and controlled.

Stop condition

  • Stop if cable movement is blocked, unstable, or slipping.
  • Stop if the installed setup is not confirmed.
  • Do not force the cable if torque/speed behavior appears unstable.
  • Record cable OD, duct OD / connection size, duct ID if known, and installed setup details.

Need ElektroFOK support?

Do not force the cable. Open troubleshooting or send ElektroFOK machine and job details to support.

Open troubleshooting
Contact support

Setup
Contact