Setup wizard

HidroFOK Setup Wizard

Enter measured HidroFOK job data to review the recommended setup reference and engineering checks. Verify setup before operation.

Machine model

This setup page is fixed for HidroFOK. Confirm the machine label before using the captured data for support review.

What this wizard can do

Check cable OD against the HidroFOK 9-24 mm range.
Show HidroFOK pallet, cable nutring, nutring seal, and cable aligning references.
Check duct OD / connection size by exact matching only for 20 / 32 / 40 / 50 mm verified duct tools.
Show engineering reference values from duct ID.
Show application warnings when measurements require support review.

Cable outside diameter HidroFOK published cable range is 9-24 mm. Use the measured outside diameter.

Measured duct outside diameter (OD) Published HidroFOK duct OD range: 20–50 mm. Enter the actual outside diameter, not an adapter size.

Connection / adapter size (optional) Exact configured tool sizes: 20 / 32 / 40 / 50 mm. A different adapter size requires support review; the wizard does not assume compatibility.

Duct ID Required for a complete setup check. If unknown, leave blank and contact support; accessory recommendations remain withheld.

Installed setup details

Input required

Enter measured cable diameter

Enter the measured cable outside diameter to review HidroFOK setup reference. Add duct OD and duct ID for full application review.

Measurement check

Cable ODNot entered
Measured duct ODNot entered
Duct IDNot entered

Recommended HidroFOK setup reference

Pallet SetEnter cable OD
Cable NutringsEnter cable OD
Nutring SealsEnter cable OD
Cable Aligning PartsEnter cable OD
Duct connection toolEnter duct OD / connection size

Engineering reference

Diameter fill ratioNot checked
Area fill ratioNot checked
Radial clearanceNot checked

Setup summary

Model: HidroFOK
Cable OD: Not entered
Measured duct OD: Not entered
Duct ID: Not entered
Diameter fill ratio: Not checked
Area fill ratio: Not checked
Radial clearance: Not checked
Pallet Set: Not selected
Cable Nutrings: Not selected
Nutring Seals: Not selected
Cable Aligning Parts: Not selected
Duct connection tool: Not selected
Installed setup details: Not entered
Warnings: Measurements not checked
Need: enter measured cable OD

Contact support Open troubleshooting

Setup reference caution

This wizard provides setup reference only. It does not provide pressure values, feed values, compressor data, availability data, or internal system codes. Verify selected setup and application suitability before operation.