Setup wizard

MikroFOK Setup Wizard

Enter measured MikroFOK job data to review the recommended setup reference and engineering checks. Verify setup before operation.

Machine model

This setup page is fixed for MikroFOK. Confirm the machine label before using the captured data for support review.

What this wizard can do

Check cable OD against the MikroFOK 1-6 mm range.
Show MikroFOK cable pushing roll and cable nutring / seal references.
Check actual duct OD and connection size separately; exact tool matching only.
Show engineering reference values from duct ID.
Show application warnings when measurements require support review.

Cable outside diameter

MikroFOK published cable range is 1-6 mm. Use the measured outside diameter.

Measured duct outside diameter (OD)

Published MikroFOK duct OD range: 6–20 mm. Enter the actual outside diameter, not an adapter size.

Connection / adapter size (optional)

Exact configured tool sizes: 6 / 10 mm. A different adapter size requires support review; the wizard does not assume compatibility.

Duct ID

Required for a complete setup check. If unknown, leave blank and contact support; accessory recommendations remain withheld.

Installed setup details

Input required

Enter measured cable diameter

Enter the measured cable outside diameter to review MikroFOK setup reference. Add duct OD and duct ID for full application review.

Measurement check

Cable ODNot entered
Measured duct ODNot entered
Duct IDNot entered

Recommended MikroFOK setup reference

Cable pushing rollsEnter cable OD
Cable Nutring & SealsEnter cable OD
Duct connection toolEnter duct OD / connection size

Engineering reference

Diameter fill ratioNot checked
Area fill ratioNot checked
Radial clearanceNot checked

Setup summary

Model: MikroFOK
Cable OD: Not entered
Measured duct OD: Not entered
Duct ID: Not entered
Diameter fill ratio: Not checked
Area fill ratio: Not checked
Radial clearance: Not checked
Cable pushing rolls: Not selected
Cable Nutring & Seals: Not selected
Duct connection tool: Not selected
Installed setup details: Not entered
Warnings: Measurements not checked
Need: enter measured cable OD

Contact support
Open troubleshooting

Setup reference caution

This wizard provides setup reference only. It does not provide pressure values, feed values, compressor data, availability data, or internal system codes. Verify selected setup and application suitability before operation.